I am running 1.048 on Steam and Windows 10. I can not get the IDS scaling to work. I push the number pad 9 and get a beep and the IDS scale on the HUD flickers for a second but then stays at 1. If I push the number pad 7, I get a lower tone beep which is what I expect.
I am running no mods and I checked in options and confirmed that the IDS increase and decrease scale buttons are still set to numpad 7 and 9.
Any ideas?
IDS scaling not working
-
SeeJay
- Captain
- Posts: 3507
- Joined: Wed Aug 11, 2010 9:03 am
- Location: Sweden
IDS scaling not working
Have you checked so it's not binded to an axis/slider as well?
\"Nothing is impossible, it only takes a bit longer!\"
\"We are not retreating, we are advancing in another direction!\"
http://evochron.junholt.se (Old)
http://www.evochron2.junholt.se (New)
http://mercenary.junholt.se (Map)
http://www.junholt.se/evoschool/index.htm (No spoilers)
-8- Bzzzzzzzzz! -8- -8-
\"We are not retreating, we are advancing in another direction!\"
http://evochron.junholt.se (Old)
http://www.evochron2.junholt.se (New)
http://mercenary.junholt.se (Map)
http://www.junholt.se/evoschool/index.htm (No spoilers)
-8- Bzzzzzzzzz! -8- -8-
-
jflatto
- Ensign
- Posts: 21
- Joined: Tue Jan 31, 2012 8:44 pm
IDS scaling not working
Details. Which is what I tell my wife when I make a mistake. 
Didn't realize that the IDS scale was bound to my slider on the X52.
Thanks.
Didn't realize that the IDS scale was bound to my slider on the X52.
Thanks.