I'm using a saitek p2500 gamepad and would like to use the right analog stick for throttle control. I set the axis but when the stick is nuetral im at half throttle. Is there any way to calibrate it to be at a dead stop and only ad throttle when i push the stick forward?
Ender
gamepad configuration
-
MMaggio
- Captain
- Posts: 1535
- Joined: Tue Jul 29, 2003 1:56 pm
- Location: Jupiter, Fl
gamepad configuration
Not by using the in-game configuration.
Is the "stick" you are referring to, "programmable"? If so, it might be possible thru that but I doubt it.
A "joystick" just isn't designed for that type of control.
Good Luck!
Is the "stick" you are referring to, "programmable"? If so, it might be possible thru that but I doubt it.
A "joystick" just isn't designed for that type of control.
Good Luck!
\"To kill hubris with humility is a goal rarely achieved by men\"
-
legrinch75
- Ensign
- Posts: 14
- Joined: Sun Feb 10, 2013 5:35 pm
gamepad configuration
Hello,
i would like to know how do you configure axis on your gamepads to move "head pilot" ?
like this :
http://www.youtube.com/watch?feature=player_embedded&v=yF-1r51Bseg
I would like to assign "tilt sensor" of my pad to move "the eyes of the pilot"
thank you !
[Edited on 3-20-2013 by legrinch75]
i would like to know how do you configure axis on your gamepads to move "head pilot" ?
like this :
http://www.youtube.com/watch?feature=player_embedded&v=yF-1r51Bseg
I would like to assign "tilt sensor" of my pad to move "the eyes of the pilot"
thank you !
[Edited on 3-20-2013 by legrinch75]