How to get back into intro missions

-Pv- · Post by **-Pv-** » Mon Jun 23, 2014 4:34 am

I played three starting contracts given by the scripted engine and now I'm not getting any more.
The first I think was to land on New Hope, then the race, then I cleaned an array.; I fulfilled each mission on the same game instance I agreed to take it.

I don't see anything wrong with my pilot status or stats.

Now, all I get are the missions while docked and no special information or any benefits.

Are those three all there is?

If not, how do I get back on the scripted track? Start a new pilot?
Just made my 1st 100,000 and hate to lose it so soon.
-Pv-

SeeJay · Post by **SeeJay** » Mon Jun 23, 2014 4:44 am

Hi and welcome.

Press F3, News then "Read last Quest message".
There you'll see where you need to go.

If it's a Race, that needs to be done in SP.
All other missions can be done in MP.

Good luck.

-Pv- · Post by **-Pv-** » Mon Jun 23, 2014 4:53 am

Thanks. I read it and it wants me to do the array clean again?
I looked back through the pilot history and I have fulfilled it twice so this would be the third time in about 10 missions total so far.

Is this typical?

I just bought the game today and have not done any multiplayer.

Added:
I did the clean mission again. Got mission accomplished message and paid.
No more messages from the Quest engine.

When I click on the read last again, it gives me the same array clean mission again. Looks like I'm stuck in some kind of loop.
Not fun.

-Pv-

[Edited on 6-23-2014 by -Pv-]

SeeJay · Post by **SeeJay** » Mon Jun 23, 2014 5:11 am

I guess you are doing the contract at the
wrong location Read the message closelly
and when accepting a quest contract, it
should be labeled "IMG".

-Pv- · Post by **-Pv-** » Mon Jun 23, 2014 5:36 am

That was my mistake.
-Pv-